Modern cars and trucks in and around Arnold run on 12 volt electrical systems. 12 volts is enough to get the job done without having so much power that there is danger of electrocution. But today’s vehicles have more electrical components and do-dads than ever before. This really strains your electrical system, making it hard for the battery to keep up. Think about it: electric seats, seat heaters, power locks, windows and sun roofs. And then we have all the power outlets for our cell phones, computers, and DVD players.

We also have navigation systems and powerful stereos. Plus there are all the engine and transmission computers, traction control, stability control, anti-lock brakes, sensors and on and on. Even the security system is running off the battery while the car is turned off.

Fortunately, battery technology has given us resilient batteries that are able to meet these strenuous requirements. But the fact is, batteries just wear out over time. Eventually, every battery gets to the point where it cannot hold enough of a charge to start your car. Sometimes batteries need to be replaced because they have just worn out. Or, in other cases, they have developed a leak and need to be replaced.

Special safety precautions are taken when working with batteries in the shop at Kevin’s Car Care in Barnhart Missouri. These precautions also apply to anyone who is poking around the battery. Batteries contain sulfuric acid that can damage your eyes and burn your skin, so safety glasses and rubber gloves are a must. Be careful to not spill acid on your clothes or the vehicle’s paint. Of course, avoid short circuiting the battery as well.

Replacement batteries come in all shapes and sizes. Some cars have limited space that requires a specially shaped battery to fit. Larger engines require more powerful batteries to get them started. If you live in a cold climate you will need a more powerful battery because engines are harder to start when it is cold.

Sometimes there is quite a price range for batteries that will work in a particular car. Think of it as “good”, “better” and “best”. More expensive batteries have a longer warranty and are guaranteed to last longer. As with most things, paying a little more up front saves money in the long run.

Kevin’s Car Care
7590 US Highway 61-67
Barnhart, Missouri 63012
6364641200

Ever heard the sad tale of a staggering repair bill from a broken timing belt? Bad news. Let’s take a lesson from their woes and remember to think about our timing belt.

First, let’s review what a timing belt does. The top part of the engine, over the cylinders is called the cylinder head. The head contains the valves. There’s at least one valve that lets the fresh air into the cylinder. This air, mixed with fuel, burns to create power. Then another valve or two open to allow the exhaust out of the engine. Each cylinder has 2 to 4 valves – that’s 12 to 24 valves for a V-6, up to 32 values on a V-8. The opening and closing of the valves is done by a camshaft. The timing belt uses the rotation of the engine to drive the camshaft which opens and close the valves. It’s called a timing belt because it has to be adjusted to rotate the camshaft to keep proper time with the engine so that everything’s in sync.

The timing belt is a toothed rubber belt . But some cars use a timing chain or timing gears instead of a belt. Timing chains and gears are much more durable, but manufacturers are using belts more because they are quieter – and cheaper. If you have a small or mid-sized passenger car, crossover or mini-van, chances are you have a timing belt.

Unfortunately, timing belts fail without any warning. That shuts you down right away. A technician can inspect your timing belt and look for cracks and looseness. But getting to the belt to take a look can be almost as much work as changing it on some cars. That’s why manufacturers recommend replacing the belt from time to time. For most vehicles it’s from 60,000 to 90,000 miles or 95,000 to a 145,000 kilometers. If your owners’ manual doesn’t specify an interval ask your service advisor.

One AutoNetTV producer has had two timing belts fail. The first was while he was waiting at a stop light – that repair cost several thousand dollars. The second was while driving on the highway – that one cost more than twice as much. Both had the cars out in the shop for three weeks. His cars had what we call “interference engines”, meaning that the valves and pistons are very close to each other. If the timing belt slips even one notch, the pistons will slam into the open valves. That’s why our friend’s highway failure was so much more expensive – his engine was traveling so fast that the valves were smashed and they chewed up the cylinder head.

A non-interference engine will just shut down if the timing belt breaks. You’re stranded, but the engine doesn’t suffer permanent damage. In both cases, our hapless friend was just a couple oil changes past the recommended interval for changing the timing belt. This is one of those things that you just cannot put off. Now replacing a timing belt is not cheap – but repairs for a broken belt can be many times as much.

Check your owners’ manual right away – especially if you have more than a 60,000 miles or 95,000 kilometers. You may need to get that belt replaced right away. And on many cars, the timing belt drives the water pump. So, it may be a good idea to replace the water pump while you’re at it because 90% of the work required for the new pump is already done with the belt change. Doing both at the same time saves you a lot of money because as they say, “timing’s everything”. Parts, Timing Belt

Today we want to talk about timing belts. They’re something that many Barnhart drivers don’t know much about and yet your vehicle won’t run if it’s broken – and it could cause many thousands of dollars damage if it does break. A broken timing belt is usually a tale of woe. Even though timing belt replacement is scheduled in the owner’s manual, it’s not the kind of thing that most St. Louis car owners remember because it’s not well understood.

Let’s review what a timing belt does. As you know, the engine’s power is generated in the cylinders. A piston rides up and down in the cylinder. During the first down stroke, an intake valve at the top of the cylinder opens and air and fuel is drawn into the cylinder. Then the piston returns to the top, compressing the fuel and air mix. At the top, the spark plug fires, igniting the fuel pushing the piston down in the power stroke. As the piston once again returns up in the final stroke of the cycle, an exhaust valve opens at the top of the cylinder and the exhaust is pushed out. The timing belt is what coordinates the opening and closing of the intake and exhaust valves. It’s called a timing belt because the valves have to open and close at just the right time.

Now, not all Imperial and Arnold vehicles have timing belts. Some have timing chains. Like the name implies, they use a chain rather than a belt to perform the function. It used to be that most engines used timing chains, which are extremely durable. Manufacturers started using belts rather than chains to save money in the manufacturing process. So now we’re left with a component that can break. They sort of shifted the problem to us. There are two broad categories of engine design: interference and non-interference. If the timing belt on a non-interference engine breaks, the engine simply stops running. That could be very dangerous depending on where you are at the time, but it causes no internal engine damage.

Interference engines, on the other hand, will get real messed up when the timing belt breaks, because the valves will actually fall down into the path of the pistons. Things get chewed up when that happens and it’ll cost thousands to repair the engine.

So, what are the warning signs? Unfortunately, there really aren’t any. There aren’t tell-tale sounds. In some vehicles, a technician from Kevin’s Car Care may be able to see part of the belt for a visual inspection, but many have a cover that’s in the way. The reality is that if the belt slips even one notch, it might as well be broken for all the damage it’ll cause. There’s no middle ground.

So how can we avoid these problems? Simply replace the timing belt when your owner’s manual calls for it. It can be 60,000 miles; it might be 90,000 or 100,000 miles. The point is, if you have 60,000 or more miles, ask your Kevin’s Car Care service advisor right away if your manufacturer requires a timing belt replacement.

Contact Kevin’s Car Care to learn more about your car’s Timing Belt
You can find us at:
7590 US Highway 61-67
Barnhart, Missouri 63012
Or call us at 6364641200

Sometimes you can go quite a while without a failure, but we’ve seen them happen within a couple of oil changes of being due. It’s not worth the risk.

What does it cost to replace a timing belt in Arnold or Festus? Well, that really depends on what kind of car you have. I can tell you that it’s usually not very easy to get to the timing belt – you often have to remove some accessories to get at it. It isn’t a cheap procedure, but it’s a fraction of what it could cost to repair the damage caused by a failure.

At Kevin’s Car Care we’re all about trying to prevent costly repairs, keeping you and your passengers safe and increasing your driving enjoyment. Thanks to AutoNetTV for their great auto video tips.

Don’t you hate it when you hear that squeal from under the hood when you’re driving aroun St. Louis? It usually means there is a problem with the serpentine belt. The serpentine belt powers a lot of engine accessories. It runs the alternator-which charges the battery, the water pump-which cools the engine, the air conditioning and the power steering pump. All pretty important parts. It is called a serpentine belt because it snakes around a bunch of engine components.

Kevin’s Car Care
7590 US Highway 61-67
Barnhart, Missouri 63012
6364641200

Serpentine belts are especially tough. They can last for years and go for tens of thousands of miles. But, with time they wear out. If your belt breaks while you are driving, everything will come to a halt within minutes. You have to stop the car or it will overheat, potentially causing major engine damage. And it probably won’t be at a convenient time or place. You might even need to get your car towed to a service center. That is why manufacturers recommend a belt replacement on schedule. You really should get it done on schedule because a belt failure will definitely take you off the road.

If you hear a squeal when accelerating or a slow, slapping sound at idle, you should have your serpentine belt looked at. Your St. Louis area service technician at Kevin’s Car Care will visually inspect your belt to see if it needs to be changed sooner than scheduled. If the belt has more than three or four cracks an inch, has deep cracks that penetrate half the depth of the belt, is frayed, is missing pieces or has a shiny glazed look, it needs to be replaced regardless of age or mileage.

Serpentine belt replacement is relatively inexpensive, especially compared with the cost and inconvenience of being stranded or getting a disabled vehicle back to Kevin’s Car Care for repairs.

An ounce of prevention is worth a pound of cure.

Local St. Louis roadside emergencies can range from a flat tire downtown to being stranded in a snowy ravine for three days. So you may want to consider a basic emergency kit to keep in the car at all times and a travel kit tailored to a specific trip.

Your close-to-home kit for around Barnhart would have some basic items to work on your car: everything you need to change a tire, gloves, a couple quarts of oil, some antifreeze and water. A can of tire inflator is a great temporary fix for minor flats. You’ll also want jumper cables or a booster box, flares, a flashlight and some basic hand tools.

Now for your comfort and safety: a first aid kit, drinkable water, high calorie food (like energy bars), blankets, toilet paper, cell phone, towel, hat and boots. Keep some change for a pay phone, emergency cash and a credit card.

People who live in areas with frequent severe weather or earthquakes may want to carry provisions for longer emergencies.

For trips away from home, consider the weather and geography as you assemble your emergency supplies. You’ll need to have a source of light and heat and will want to provide protection against the elements as well as adequate food and water for everyone in the car.

Always tell people where you are going and have a plan for checking in at waypoints. Then if you run into trouble, you can be reported missing as soon as possible and rescuers will be able to narrow the search area.

The key to safe travel is to keep your vehicle properly maintained, plan ahead, and let others know your itinerary.

The energy from exploding fuel is what powers your engine. But some of the vapors from the explosions escape into the lower part of the engine, called the crankcase. The crankcase is where your engine oil hangs out. These gases are about 70% unburned fuel. If the gases were allowed to stay in the crankcase, they would quickly contaminate the oil and turn it to sludge. Sludge is one of the biggest enemies of your engine, clogging it up, eventually leading to expensive failures. Also, the pressure build up would cause seals and gaskets to blow out. Therefore, these gases need to be vented out.

Gasoline engines used to simply have a hose that let the poisonous fumes vent out into the air. In 1963, the federal government required gas engines to have a special one-way valve installed to help reduce dangerous emissions. Diesel engines are not required to have these valves.

The positive crankcase ventilation, or PCV, valve routes crankcase gases through a hose and back into the air intake system where they are re-burned in the engine. Fresh, clean air is brought into the crankcase through a breather tube. It’s really a pretty simple system, but does an important job. The re-circulating air removes moisture and combustion waste from the crankcase, preventing sludge. This extends not only the life of your oil, but the engine as well. The PCV relieves pressure in the crankcase, preventing oil leaks.

Eventually, the PCV valve can get gummed up. Then it can not move enough air through the engine to keep it working efficiently. If the PCV valve is sticking enough, you could have oil leaks, excess oil consumption and a fouled intake system. If you experience hesitation or surging or an oil leak, it may be a sign of PCV value problems. Your owners’ manual may give a recommendation for when the PCV valve should be replaced – usually between 20,000 mi/32,000 km and 50,000 mi/80,000 km. Unfortunately, some manufacturers don’t list a recommendation in the manual, so it can be easy to overlook.

Many PCV system problems can be diagnosed with a visual inspection. Fortunately, PCV valve replacement is both quick and inexpensive. Proper oil changes will greatly extend the life of the PCV valve. Skipping a few recommended oil changes can allow varnish and gum to build up in the valve, reducing its efficiency. So now when your Barnhart service technician tells you its time to replace your PCV valve, you will know what he’s talking about. If you have had your car for a while and this is the first you’ve ever heard of a PCV value, ask your tech to check yours out or call Kevin’s Car Care at 6364641200.